NuPool

2K Epoxy Concrete Coating

NuPool is a high build, two-component gloss epoxy coating that is impervious to water and moisture and is suitable for use as a quality swimming pool coating for new concrete pools, or re-coating aged 2K epoxy coated pools. This two pack pool paint is long wearing and can be used in conjunction with Nutech Anti-Slip.

NuPool Features

  • Resistant to salt water and pool chlorination chemicals
  • Algae Controlled
  • Durable
  • Safe for fish and mammals
  • Easy to maintain
  • Brush or roller application
  • 13 standard colours
  • Colour matching available

Nutech NuPool - 4 Litre Kit


Nutech NuPool - 10 Litre Kit

Application

Equipment & Tools

Brush or Roller

Pressure washer and vacuum cleaner

Drop sheets, cardboard or old tarps

 

Preparation

  • Pressure clean the entire pool with a >3000psi pressure washer
  • For bare concrete, etch the surface using Nu-EcoSafe Etch and rinse well
  • For old or existing 2K epoxy surfaces, sand or abrade the entire surface
  • Make any spot repairs to cracks or chips
  • Vacuum the entire pool with a soft bristle head. Ensure that all debris has been removed
  • Create a safe mixing area near the pool with drop sheets, tarps or cardboard

Coat One

  • Mix the first coat of NuPool using the 3:1 ratio (2-part kit) by adding NuPool Part B into NuPool Part A
  • Mix the 2 parts together throughly using a drill mixer
  • Add EPiC Epoxy 500 Thinner (approx 20%) and mix again
  • Allow the paint to stand for 10 minutes before application
  • Use a brush to cut in all edges and corners with NuPool, then roll to cover the surface
  • Allow to dry for 5 hours (temperature dependant), before applying the second coat
  • DO NOT wait more that 48 hours before applying a second coat

Coat Two

  • Mix the second coat of NuPool using the 3:1 ratio (2-part kit) by adding NuPool Part B into NuPool Part A
  • Mix the 2 parts together throughly using a drill mixer
  • Allow the paint to stand for 10 minutes before application
  • Use a brush to cut in all edges and corners with NuPool, then roll to cover the surface
  • Allow to dry for 5 hours (temperature dependant)

Non-Slip

  • To create a non-slip surface, apply Nutech Coarse Anti-Slip to the second coat while it is still wet
  • If anti-slip has been applied, use a third coat of NuPool over the areas

Curing

NuPool takes 7 days to completely cure into a hard and durable surface. During this time, the pool must be kept dry. If the surface becomes wet, remove all water and allow to continue curing. 

 

Safety Precautions

Proper safety procedures should be followed at all times while handling the product.

Refer to the Material Safety Data Sheet for important health and safety information before use.

Important Note

The information given in this data sheet is based on many years experience and is correct to the best of our knowledge. However as the use of our product is beyond our control we can only be responsible for the quality of our product at the time of dispatch. For additional information about specifications or application please contact our company. As this information is of a general nature we cannot assume responsibility for individual use.